How long have I owned a serger? It’s gotta be close to 25 years. Most of the serger sewing I do works perfectly fine and I’m happy with it. However, when I need to sew in the round (like when attaching the neckband to a t-Shirt, or at the bottom edge of pants), when I stitch past the place where I started, I end up trimming the edge of the beginning stitches. It annoys me – I usually end up zig-zagging across that small part of the edge. The other day, I figured out how to solve that problem (although why it’s taken me 25 years to do that, I don’t know!).
This is the normal cutting position with the knife blade (upper right corner) in the up position beside the presser foot (and the small white knob on the left with no writing).
I realized the other day that when I reached the place where I started stitching in the round all I had to do was lower the knife to the down/lock position (below the presser foot, in line with the needle plate, with the small knob on the left showing “lock”), and here’s what I get:
No trimmed stitches! I can connect the join and not worry about that centimetre of trimmed stitches in front of where I stopped serging! (The trimming happens because the cutting knife is in front of the needles and trims the seam edge before it gets sewn – in the round it catches and trims the already serged edge.)
I have a second tip. The other day, I was helping a friend set up her new coverstitch machine (that’s a sewing machine that only does a three thread coverstitch – just look at the hem on your t-Shirt – that’s a three thread coverstitch). Threading the needles is straightforward. Threading the looper (on her machine, that’s to the left side) is not intuitive and involves some very awkward threading from back-to-front on the looper itself.
I pointed out to her that she only ever needed to thread the machine once, then she never have to thread that looper again – just cut the thread at the spool, tie on the new coloured thread, make sure she’s raised the presser foot to release the tension on the tension disks, then pull on the old looper thread bringing the new thread through the entire thread path.
It’s the same with a serger – cut the looper threads (on a serger there are two loopers) near the spool, tie on the new colour thread, raise the presser foot, pull the new thread through the machine. I actually do that with all four threads even though I’ve not figured out how to tied a tiny knot that will go through the needle eye – I just cut the needle threads when the new thread reaches the eye and re-thread the needles with the new colour. I use an overhand knot (which I pull snug) – I’ve tried reef knots but they’re no smaller.
Threading the needle paths on a serger or coverstitch machine from spool to needle is easy; it’s the loopers that can be complicated. Tying the new threads on and pulling them through is an easy fix.