These pants were cut based on the modifications I made to my basic pattern in San Francisco – a small addition to the centre front crotch area, a 3/4″ drop in the front waist, and 1/4″ addition to the side seams because the fabric had no spandex.

This is a jeans pattern but I thought this wool/polyester fabric was a bit too “dressy” to turn into jeans so I left out all the top stitching, omitted the back pockets, and used a single seam for a neat hem.

Have to say they turned out pretty well – although everything that could go wrong did! I started by putting the zipper on the wrong side of the fly front, had to redo it, pockets went in fine as did the side seams, but I screwed up threading the embroidery machine and I had to take out a stitched (not yet cut, fortunately) buttonhole not once but twice. After rethreading the machine and doing a practice buttonhole (which I should have done in the first place) the third try was fine. Only then did I cut it open.

I’ve just finished cutting pants out of a beige fabric which I will sew tomorrow. The beige fabric I used for pants in San Francisco turned out to be dreadful – it’s a stretch twill and it now has a permanent stretch across the front where the spandex has failed – very visible. So once these new beige pants (with almost no stretch) are done, the SF pants will get tossed. 

That’s the same fabric I used for the light and dark blue pants I made earlier in the spring – they’re starting to show the same permanent stress marks across the front so they’ll have to be replaced. This time, I’ll use a cotton twill with no spandex in it. The original fabric wasn’t a cheap fabric, either. 

So lesson learned – stay away from fabrics with any amount of spandex – they may be intended to provide a comfortable fit with some give but the quality and durability is variable and pants take a good 5-6 hours of work. Too much time for such a limited result!