Diamonds II – Assembled

Here it is – the Diamonds II quilt top fully assembled:

Diamonds II – Assembled

The sewing process did get much easier as I went along. Once I’d figured out the sub-assembly groupings and sewed each segment, the parts went together very easily. I did very little taking apart and restitching.

I find it interesting that my original star in the centre is almost invisible. I chose to set up a star with those fabrics because there were three each of the solids and the leaf ombre – I couldn’t see where else to use them. However, although the colour of those diamonds is strong, it’s overpowered by the other fabrics and what pops out when you’re not looking at cubes are the two red six-point stars; you almost don’t see the star in the middle.

In any case, this is how the top is going to stay. If I trimmed the side diamonds I’d be able to get away with a single length of backing fabric (provided I find a fabric that complements the wild colour range of the top). Of course, I can always add a single strip with end to end diamonds which I would need to do were I to make the panel wider.

I just measured the finished dimensions: Length = 66.5″ (that’s a reasonable length for a throw or wall hanging); width = 43.5″ if I trim the outlying diamonds. If I add half diamonds in those spaces I can grow the width to 49.5″.

I think I have to add the half-diamonds. Which fabrics? Gotta think about that a bit.

Lots of decisions remain.